GF5330 Brushless DC motor out runner 180kv-200kv


$120.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
GF5330 Brushless DC motor out runner 180kv-200kv
Please tell us what KV you need in check out description
New Generation GF motor GF-5330
1. Curved NdFeB permanent magnets with higher temperature and magnetic density grades(N45UH)
2. Reinforced overall structure , optimizing motor case design improve heat dissipation and
reduce weight at same time
3. Adopt imported five-axis machining center to improve the concentrically of the motor and
minimize the amount of subsequent dynamic balance mud usage
4. Thinner and more powerful through adopt 0.15mm silicon steel sheet, reduce iron loss
and improve efficiency more than 10%.
5.The casing secondary processing, beautiful and elegant6.Full set of accessories, fine workmanship
Product Details
GF-5330
KV: 180kv-200kv
Weight: 617
Poles:12N14P
Power : 10watts-11watts
Burst current: 76amps
power: 24v-48v
GF5330 Brushless DC motor out runner 180kv-200kv
GF5330 Brushless DC motor out runner 180kv-200kv
GF5330 Brushless DC motor out runner 180kv-200kv
GF5330 Brushless DC motor out runner 180kv-200kv
GF5330 Brushless DC motor out runner 180kv-200kv
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 29 April, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here