T-MOTOR P60 Pin 340KV 6S Brushless Motor for drone


$141.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
The TMotor UAV Brushless Motor P60 340Kv offers more power & efficiency. Weight decrease is achieved by optimizing stator structure while maintaining its mechanical strength.
Manual winding helps increase slot fullness for a thrust above 8kg with the power of more than 1800W. 24N28P configuration reduces motor vibration in operation for motor wearing diminution, service life extension, and noise debasement. Motors run more smoothly than motors with the general configuration at max. throttle.
The optimized machining precision and motor structure with motor core part protection effectively avoid cases as to the failure in motor utilization after crash and impact. The closed exterior and lattice structure takes account of both dustproof. Waterproof and cooling effects which handle usage in various environment.
Product Details
Internal Resistance: 35mΩ
Shaft Diameter: 6 mm
Stator Diameter: 62 mm
AWG: 16#
Weight Including Cables: 375 g
No.ofCells(Lipo): 6-8S
Max Continuous Power: 1550 W
Configuration: 24N28P
Stator Height: 15 mm
Cable Length: 600 mm
Weight Excluding Cables: 345 g
Idle Current: 2 A
Max Continuous current: 65 A
Item Packing
1
Detailed Images
T-MOTOR P60 Pin 340KV 6S Brushless Motor for Quadcopter MultiRotor Rc Drone T-MOTOR P60 Pin 340KV 6S Brushless Motor for Quadcopter MultiRotor Rc Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 09 October, 2020.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here