Cable cam wirecam BGC gimbal cable rig up to 10kg payload


$3,999.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Cable Cam system that flies a camera over a rope tied between two points. Although the affordability and use of drones are increasing for aerial imaging, there are still many instances in which a Drone would either not work, would be illegal, unsafe, or would be just a noisy nuisance. Uses 1:7 Gear Ratio Provides high toque through 1:7 gear ratio. For the main driving part wheel, we used urethane material support 1kg to 10kg
35MM BALL-HEAD
WE HAVE ATTACHED A BALL-HEAD TO ALLOW ANGLE ADJUSTMENTS TO RETAIN GOOD
ANGLES FOR SHOOTING
Quality Aluminum Alloy, Steel, Rubber
Weight 3.3kg (7.26 lb)
Maximum Speed 40km
Body Length 668 x 210 x 118mm Wire Setting Distance Maximum 100m
Weight of Installation 20kg (44lb) (including the Wire Cam) Recommended: 9kg (19.8lb) Inclination angle Below 20 degrees
Li-Po Battery
Voltage 7.4 V 5200mAh (Basic Supply)
Consecutive Time 20~40 minutes (fully charged) Charging Time 70~80 minutes
AT9 or similar RC TXRX
Frequency Range 2.4 GHz
Weight 648g
Length 180 x 200 x 65 mm
Steel Wire
Quality Steel
Diameter 6mm
Length 50m
Weight 4.5kg
Hard Case
Outside Side 837 x 430 x 219 mm
Inside Size 820 x 410 x 210 mm
Buoyancy 67.2 kg (147.84 lb)
Weight 7.8 kg (17.16 lb)
Cable cam wirecam BGC gimbal cable rig up to 10kg payload
Cable cam kit by wirecam for BGC gimbal cable rig up to 10kg payload
Cable cam wirecam BGC gimbal cable rig up to 10kg payload
Cable cam wirecam BGC gimbal cable rig up to 10kg payload
Cable cam wirecam BGC gimbal cable rig up to 10kg payload
Cable cam wirecam BGC gimbal cable rig up to 10kg payload
Cable cam wirecam BGC gimbal cable rig up to 10kg payload
Cable cam wirecam BGC gimbal cable rig up to 10kg payload
Cable cam wirecam BGC gimbal cable rig up to 10kg payload
Cable cam wirecam BGC gimbal cable rig up to 10kg payload
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 18 September, 2017.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here