50kw VESC 100V 500A in Sealed water proof CNC Aluminum Enclosure


$1,599.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Express shipping only for this product $60 int by DHL/FedEx
Voltage: 14V – 100V (Safe for 4S to 22S LiIon).
Voltage spikes may not exceed 100V!
· Current: Continuous 200-250A, Burst 400A. Values depend on the mounting,
ambient temperature and air/water circulation around the device!
· 5V and 12V 1A output for external electronics
· 3.3V 0,5A output for external electronics
· Modes: DC, BLDC, FOC (sinusoidal)
· Supported sensors: ABI, HALL, AS5047
· up to 150K ERPM drivable
· Accurate current and voltage measurement on all motor phases (3x shunts)
· Regenerative braking
· Sensored or sensorless operation + hybrid mode
· Configurable RPM-, current-, voltage- and power limits
· Input source: PPM, Analog, NRF Nyko Kama Nunchuck
· Communication ports: USB, CAN, UART
· Throttle curve and ramping for all input sources
· Seamless 4-quadrant operation
· Motor revolution, amp hour, watt hour counting
· Real time data analysis and read out via communication ports
· Adjustable protection against:
- Low input voltage
- High input voltage
- High motor current
- High input current
- High regenerative braking current (separate limits for the motor and the input)
- High RPM (separate limits for each direction).
- Over temperature (MOSFET and motor)
Product Details
With this VESC you get the following items
VESC Box Length 141mm
VESC Box Width 82mm
VESC Box Height 18mm
XT90 cable length approx 70mm
1x VESC 100V 500A
1x VESC 100/500 Bus Bar 1
1x VESC 100/500 Bus Bar 2
1x VESC 100/500 SILICON Pressure Pad - 2mm
1x VESC 100/500 SILICON Seal 1mm
1x VESC 100/500 SILICON Pressure Pad - 3mm
1x VESC 300 CNC Aluminum Heat Sink Housing - Black
3x 4mm FEMALE Bullet connector - GC4010-F
Weight: 494g
VESC-100/250
50kw VESC 100V 500A in Sealed CNC Aluminum Enclosure T6 Silicone wire 4mm Bullet connector
VESC 100V 500A Manuel
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 21/137

 Prev 
 All 
 Next 

This product was added to our catalog on Friday 11 March, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here