DYS Aria BLHeli 32bit 70A Brushless ESC 3-6S Dshot1200


$29.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
1、With 32bit ARM Cortex MCU STM32F051 48MHZ micro processor, throttle 2048 resolution ratio,strong anti-interference capacity.
2、Built-in temperature sensor will pass the telemetry port to transfer and overlay to the OSD of FC,It can be programmed setting for temperature protection.
3、Support Blheli_32 firmware,can use the signal wire to upgrade the firmware or change the configuration on line.
4、Current Meter to help show current indication of OSD;
5、With USB linker can be programmable throttle setting like support positive and negative,two-way mode,FPV 3D mode,motor speed,braking , PWM frequency,
inlet angle speed setting, onboard RGB LED for customize color, Beep etc.
6、It use the self-adaption control system,can go automatic with the all kind of the motor in the market,at the mean time it support up to 500HZ PWM,oneshot 125,
oneshot 42,Multishot and Dshot 150/300/600/1200.
7、With special optimize in multi-axis,the motor can launch smoother in a good throttle curve, fast response,great power, and highly support the multi-axis,fixed-wing and helicopter.
8、The twisted- pair signal wire can lower the crosstalk inside cooper wire when it transfer,which will make the flight more stable.
9、MCU hardware,Driver circuit ,Mosfet will come with double voltage protection.
10、To adopt the new process MOSFET of low internal resistance, will help increase resistance to flow.Also,the professional MOS driver chip makes the best efficiency.
11、Mosfet is covered with aluminum sheet for cooling,which can bring more efficiency and stability.
12、With special process of 8 layer thicken PCB will lower resistance, small calorific value and bigger impact resistance current.Nice optimize layout of the components
and parts makes a smaller size,lighter weight and easy to build
Product Details
Brand: DYS
Item name: Aria BLHeli_32 70A ESC
Con. current: 70A
Burst current(A)>10s: 80A
Input voltage: 3-6S Lipo
BEC: NO
Size: 42mm x 21mm x 6mm (LxWxH)
Weight: about 9.50g
Item Packing
6
Detailed Images
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 12 April, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here