Hobbywing XRotor Micro BLHeli 20A 2-4S ESC Support OneShot125


$14.20

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
1. Super Small & Light: ESCs with incredible small size and light weight are specially designed for competition FPV drones
2. Quality components: F396 48MHz MCU, 3-in-1 drive IC, High quality MOSFETs
3. BLHeli firmware ready: Users can flash or upgrade the BLHeli firmware via the signal cable (on ESCs), and program 4 ESCs simultaneously after connecting their flight controller to the BLHeliSuite software if the flight controller uses the CleanFlight firmware
4. Damped Light Mode & OneShot125 Mode Supported: Damped light mode improves the motor retardation and allows users to brake the FPV drones more efficiently. Active-freewheeling, technology improves driving efficiency, flight time and heat dissipation. The ESCs support OneShot125 high speed throttle, signal and regular throttle signal (within 500Hz) modes
5. Twisted-Pair Signal Cable Reduces Interference: Effectively reduces interference produced in signal, transmission and makes the flight much more stable and reliable
Product Details
Product Name: XRotor micro 20A BLHeli
Cont./Peak Current: 20A/30A
LiPo Cells: 2-4S LiPo
BEC Output : NO
DEO: Not Supported
OneShot Mode: Supported
Timing: Supported
Light Color: Not Supported
Motor Rotation: Supported
Throttle Range Calibration: Supported
Stick Programming: Stick Programming/BLHeliSuite
Size(mm)L*W*H: 24x13.9x5.5mm
Weight: 6.8g
Applications: FPVs with 130-280mm Diagonal Wheelbase
Hobbywing XRotor Micro BLHeli 20A
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 19 July, 2016.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here