Hobbywing XRotor Micro BLHeli-S 30A for competition FPV drone(s)


$21.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Super Small & Light
With the remarkably small size (23.8x14.5x5.8mm) and light weight (6g), XRotor Micro BLHeli-S 30A is an ESC specially designed for competition FPV drone(s).
The use of EMF8BB21F16G MCU (with the operating frequency of up to 48MHz), 3-in-1 drive IC, American Fairchild MOSFETs, imported quality ceramic capacitors, 3-ounce copper and 4 layers of PCBs guarantees less heat, higher efficiency and rapider response.
BLHeli-S Firmware Ready
The ESC supports the original BLHeli_S firmware. Users can flash or upgrade the firmware via the signal cable (on ESC) and program 4 ESCs simultaneously after connecting their flight controller to the BLHeliSuite software (if the flight controller uses the CleanFlight or betaflight firmware).
Hardware Generated PWM & Damped Light Mode
The ESC firmware uses hardware generated motor pwm for smooth throttle response and silent operation. Damped light does regenerative braking, causing very fast motor retardation, and it inherently also does active freewheeling
The twisted-pair throttle signal cable effectively reduces interference produced in signal transmission and makes the flight much more stable and reliable
Product Details
Cont./Peak Current:30A/40A
LiPo Cells:2-4S LiPo
BEC Output:NO
Input Wires:Red-18AWG-100mm*1 / Black-18AWG-100mm*1
Output Wires:No wires but solder tabs
Input Connectors:No
Output Connectors:No
(Note: All the wire length above is the original length not the length you see from the outside.)
Firmware:BLHeli-S A-H-50 16.3
ESC Programming:Stick Programming,BLHeliSuite
Stick Programming:Supported
DEO:Supported
Throttle Range Calibration:Supported
Oneshot125 Mode:Supported
Oneshot42 Mode:Supported
MultiShot Mode:Supported
Timing:Supported
Motor Rotatio:Supported
Size;23.8x14.5x5.8mm
Weight;6g
Applications;150-280mm FPVs
Hobbywing XRotor Micro BLHeli-S 30A for competition FPV drone(s)
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 02 November, 2016.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here