Holybro FETtec 4in1 45A ESC 3-6S 128K PWM DSHOT2400 KISS


$130.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
The FETtec 45A 3-6S ESC is a powerful 4-in-1 electronic speed controller $130
that has a mounting pattern of 30.5x30.5 and supports Dshot 300-2400, OneShot
42/125, PWM, Crossfire, SBUS, and other features!
Product Details
Active current limiting @ 45A
Input voltage: 3S-6S
High-quality 40V MOSFETs
STM32G071 @ 64MHz
128 kHz Motor PWM
Full sine wave control
* Soldering holes for up to 5 additional capacitors
* KISS FC Passthrough
* Betaflight Passthrough (available in 4.1)
* Automatic input signal detection:
- Dshot 300-2400
- PWM
- OneShot 42/125
- OneWire BUS with up to 8kHz loop time
(one cable for all Motorsignals and Telemetry)
- In development: Crossfire, SBUS
* 38 mm x 38 mm
* Mounting hole: 30.5 mm x 30.5 mm, M3 expandable to M4
1 x FETtec ESC 4in1 45A
1 x Capacitor 50V, ESC < 1ohm (477CKE050M)
1 x JST-SH 8 Pin Cable
FET-4IN1-45A
Holybro FETtec 4in1 45A ESC 3-6S 128K PWM DSHOT2400 KISS FC Passthrough 30X30mm for RC FPV Freestyle Drones DIY Parts
Holybro FETtec 4in1 45A ESC 3-6S 128K PWM DSHOT2400 KISS FC Passthrough 30X30mm for RC FPV Freestyle Drones DIY Parts
Holybro FETtec 4in1 45A ESC 3-6S 128K PWM DSHOT2400 KISS FC Passthrough 30X30mm for RC FPV Freestyle Drones DIY Parts
Holybro FETtec 4in1 45A ESC 3-6S 128K PWM DSHOT2400 KISS FC Passthrough 30X30mm for RC FPV Freestyle Drones DIY Parts
Holybro FETtec 4in1 45A ESC 3-6S 128K PWM DSHOT2400 KISS FC Passthrough 30X30mm for RC FPV Freestyle Drones DIY Parts
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Saturday 14 May, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here