LittleBee FVT 30A ESC for Multirotor BLHeli firmwear



$15.57

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
FVT LittleBee 30A ESC for Multirotor BLHeli OneShot125 FPV Quad Drone QAV250
FVT LittleBee 30A ESC is a super compact, lightweight, high performance speed controller for your racing multi-rotor. Pre-flashed with BLheli and ready to use with Oneshot (aka oneshot125 / PWMsync) mode via compatible flight controllers running Cleanflight or similar.
FVT Littlebee 30A ESC is using Silabs processor and fast dedicated driver chips, providing excellent freewheeling and exceptional braking capabilities. FVT Littlebee 30A ESCs have all the performance you would hope for and the same tiny size as the DYS ESC. You will struggle to find a frame small enough to fit these ESCs and they will still give you plenty of headroom on a standard 250 size quad!This ESC allows your motors to respond to throttle decreases much quicker, allowing for more stable flying, and higher response to throttle decreases.
These ESCs do not have a BEC, you will need to supply 5v power to your flight controller with a UBEC or stepdown voltage regulator.
Product Details
Input : 2-6s Lipo
Constant : 30 Amps
Burst : 40 Amp
Weight : 12g with wires
Dimensions : 34x17x3mm
MCU : Silabs F390
BEC : None
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 12 April, 2016.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here