MultiShot DYS XSC 20A V2 3-4s Lipo BLHelis ESC Support OneShot42


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
BLHeli_S V2 ESC with Hardware generated PWM synchronous to MCU yields ultra-quiet motor performance.
Utilizes high-performance EFM8BB2 50MHz MCU
BLHeli_S does Damped Light only
Firmware upgradable via signal wire (works with USB Linker for XM series) Supports Motors with super high KV (EFM8BusyBee 50MHz can handle up to 500k eRPM)
Supports 1-2ms signal, Oneshot125, Oneshot42 and Multishot. High-current burst rating
High-Resolution Throttle steps
Product Details
Brand Name: DYS
Item Name: XSC20A V2 solder version
Weight: 4.49g
Input Voltage: 3-4s Lipo
MCU: Silabs EFM8BB2
Size(mm)L*W*H: 24*14*4.5mm
Firmware: BLHeli Bootloader & BLHeli_S
Item Packing
MultiShot DYS XSC 20A V2 3-4s Lipo BLHelis ESC Support OneShot42
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Wednesday 02 November, 2016.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here