SM30A ESC With SimonK updated firmware for multicopter DYS


$25.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
2. l Drive tube and high-power Mos, and Mos tube plus a separate heat sink, Extreme low output resistance of the PCB(printed circuit board),super current endurance.
2.2 The power input uses extreme low output resistance greatly enhance the power stability, and has the protective effect on the battery.
2.3 Safety electrical function: when the power is turned on, regardless of the throttle stick in any position does not start the motor immediately, to avoid personal injury.
2.4 Separately voltage regulator IC for microprocessor. providing good anti-jamming capability.
2.5 Supported motor speed (Maximum): 210000 RPM (2 poles), 70000 RPM (6 poles), 35000 RPM (12 poles)
. 2.6 Using Simon K’s a dedicated multi-copter program tgy_debug, and the master chip with high stability crystal oscillator, making the motor control to more precise.
Product Details
1.1 Running current:30A(Output: Continuous 30A, Burst 40A up to 10 Secs.)
1.2 Input Voltage: DC 6-16.8V(2-4S Lixx)
1.3 BEC: 5V 2amp.
1.4 Size: 46mm (L) * 26mm (W) * 11mm (H).
1.5 Weight: 23g
1.6 With SimonK updated firmware for multicopter
Item Packing
-SM30A x 1
SM30A ESC With SimonK updated firmware for multicopter
SM30A ESC With SimonK updated firmware for multicopter
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 17 March, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here