Sunrise HiMulti Series Speed Controller for Multicopter


$55.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
The HiMULTI product line of speed controllers are designed for controlling and regulating brushless motors that are typically used for powering multicopters. Each speed controller is pre-set from the factory with settings optimized for use with multi rotor aircraft stabilization systems. HiMULTI controllers accept a control signal with a frequency of up to 500Hz. This allows them to accurately respond to any PRM change required by the control/stabilization unit of the multicopter.
The motor control signal is galvanically (optically) separated from the flight battery in all HiMULTI speed controllers. HiMULTI speed controllers do not require of allow any programming changes. The propeller brakes are already switched off, the cut-off voltage is pre-set to the lowest possible level (depending on type) and the motor timing is set automatically by the speed controller. If you need to change the direction of rotation simply swap any two of the motor wires.
Features
Starting program optimized
Using systerm’s structure optimized.
All N-channel MOSFET design
The refresh rate increased. The range is 20-500HZ.
Can support more voltage. All the series can support 2-6S.
Increased more power of torque.
Don’t need programming.
Product Details
Model: HiMULTI-100A-OPTO
Constant Current: 100A
Max Current: 110A for 10 seconds
Input Voltage: 5-25.2V
BEC: NO
BEC Output: NO
Response:20-500Hz
PCB Size: 50mm*30mm
Weight: 70g
Item Packing
-HiMulti-100A-OPTO X 1
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 17 March, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here