XRotor Pro 40A Speed Controller ESC TL2930


$34.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Product Description:
·XRotor Pro 40A ESC Custom manufactured by our company in cooperation with hobbywing
·Substantial adjustment of ESC size and weight
·Bare weight of ESC (not including output wire)only 20g
·Improved flight endurance and times
·Aluminum alloy heat sink for more efficient heat dissipation
·Highly intelligent and optimized user experience.
Product Features:
1.Special core program for multi-rotor controllers greatly improves throttle response.
2.DEO(Driving Efficiency Optimization)technology significantly
improves throttle linearity and driving efficiency.
3.High intelligent and adaptive default setting like
auto-adjusting timing meet almost all applications.
4.The twisted-pair design of the throttle signal cable effectively
reduces the crosstalk produced in signal transmission and makes flight more stable.
5.Compatible with various flight-control systems and supports a
signal frequency of up to 621Hz.(Note:all throttle signals over 500Hz are non-standard signals.)
Product Details
Continuous/peak current: 40A/60A
Voltage: 3-6S LiPo / 11-26V
BEC: None
Power cord: red and black 16AWG silicone wire 500mm
Signal cable: DuPont 2P cable 450mm
Motor output line: black 20AWG silicone wire 55mm
Size: length, width and height 65*20*9.8mm
Weight: bare weight without line 20g; full weight with line 35g
TL2930
Tarot Custom Edition XRotor Pro 40A Speed Controller ESC TL2930 For Helicopter Multi-rotor UAV
Tarot Custom Edition XRotor Pro 40A Speed Controller ESC TL2930 For Helicopter Multi-rotor UAV
Tarot Custom Edition XRotor Pro 40A Speed Controller ESC TL2930 For Helicopter Multi-rotor UAV
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 04 November, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here