2.4G Radio Signal Amplifier Signal Booster


$55.80

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Increase the range and reliability of your 2.4G radio system, especially for FPV application.
Special feature:
- Custom made 2.4G radio signal amplifier, especially designed for long range application like FPV.
- High speed receiving and transmitting auto-switching circuit, can switching between receiving and transmitting modes automatically.
- With the increasing on-board wireless electronic devices like FPV application, the interference between different devices also getting more and more severe, and the radio system range and reliability also greatly affected, this amplifier is just designed to increase the range and reliability of your radio system.
* Hint:
1. The module requires 3.7-5.5V power supply, higher than this voltage range may damage the module permanently and NOT covered by warranty.
2. When use BEC unit as power supply, only high quality BEC can be used otherwise it may introduce interference to the system.
Product Details
2.4G Radio Signal Amplifier / Signal Booster - Black
Receiving gain: 10dB
Transmitting gain: 11dB
Receiving figure: ≤3.0dB;
Input power range: 4dBm-20dBm
Peak power: 33dBm; 2W (input power plus amplifier power)
Power supply: 3.7-5.5V (High quality UBEC is needed when use a BEC module as power supply)
Antenna gain: 6DBI
* Below image is for showing the dimensions purpose only, the actual product is black in color.
  • 99 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 14 April, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here