30A Large Current 3.7-28V Input Remote Control Switch


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
Large current, high reliability, supports high voltage receivers, compact size, light weight.
18AWG silicon wires for power, super soft silicon wires for signal as well.
Application examples:
Switch for cars/ airplanes lights.
Switch for electronic devices like camera, A/V transmitter etc. (connect "positive" wire disconnecting the main power supply, using common GND wire) Gas/Nitro Engine ignition control, smog control etc.; You can connect electric heating wire to the device for ignition control.
Product Details
Input voltage: 3.7-28V
Input current: < 30A
Control signal type: PWM signal
Power supply wires: 18AWG silicon
Power wire total length: 20CM (approx)
Weight: 12g
Dimension: 30 x 16 x 4mm (excluding wires)
3.7-28V Input Remote Control Switch
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Friday 14 November, 2014.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here