Electric Sealing Iron for RC Plane Cover Film Prolux PX1366


$99.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
1. Precise and clear MCU to control the temperature. $99
2. Providing accurate temperature control from 100℃ to 220℃ (212℉ to 428℉).
3. Perfect for any heat shrink film or fabric covering.
4. New iron shoe makes the covering procedure easier.
5. Teflon coated shoe prevents scratching.
6. Safety stand and iron sock included.
7. Special TPR material handle design provides a
comfortable handling. It’s fitter for ergonomics.
Product Details
How to use the thermal sealing tron
First , put the iron sock into the shoe and place the iron on the metal stand.
Then, place it on the thermal insulation or poor
thermal conductivity surface(ex, Flagstone, glass table, etc.)
Plug the AC power cord to the proper wall outlet
( 110V or 220-240V ) , and the LCD starts to light on.
When in the SET Mode, turn the knob to set the temperature
(Range: 100°C to 220°C ( 212°F to 428°F ). Single press the
knob to change temperature conversion [ Celsius Fahrenheit ).
Long press the knob for three seconds to enter into START Mode ,
the sealing iron win start heating to specified temperature.
The bottom clock will also start coonting-down for 6 hours; afterward,
the system will turn down once the sealing iron remains ON for 6 hours.
The timer counts-down 6 hours or long press the knob for three seconds,
the iron will go to OFF Mode. To start another process ,
please long press the knob for seconds to go back to SET Mode.
PX1366
Prolux PX1366 110V LCD Display Electric Sealing Iron Temperature for RC Plane Cover Film RC Airplane Tools
Prolux PX1366 110V LCD Display Electric Sealing Iron Temperature for RC Plane Cover Film RC Airplane Tools
Prolux PX1366 110V LCD Display Electric Sealing Iron Temperature for RC Plane Cover Film RC Airplane Tools
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 27 October, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here