ExpresLRS Micro TX Module For Radio Transmitter Happymodel ES24T


$50.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
This Micro TX is designed by Happymodel and based on the open source- ExpressLRS which is a very popular
low latency and high re-flashed rate RF module for RC Airplane and FPV Racing. Its main hardware
architecture is ESP32, ESP8285 and SX1280 RF chip. The ES24TX module is a complete solution which
is already pre-load the Expresslrs firmware and it’s plug and play.
Product Details
Regulatory Domain: ISM2400
MCU:ESP32(main),ESP8285(aux,as espbackpack)
RF chip:SX1280IMLTRT
JR standard 5pin socket
Frequency Range: 2400 MHz to 2500 MHz
Maximum receive refresh rate: 500Hz
Minimum receiver refresh rate: 25Hz
RF Output Power: 10dBm~24dBm
Power supply voltage: 5v~10v
Weight: 9.5gram(without antenna)
Dimension: 55.5mm*39.5mm*8mm
Antenna gain:1.87dBi
ES24TX
Happymodel ES24TX 2.4G ExpresLRS Micro TX Module For Radio Transmitter TX16S TX12 RC Airplane FPV Drone
Happymodel ES24TX 2.4G ExpresLRS Micro TX Module For Radio Transmitter TX16S TX12 RC Airplane FPV Drone
Happymodel ES24TX 2.4G ExpresLRS Micro TX Module For Radio Transmitter TX16S TX12 RC Airplane FPV Drone
Happymodel ES24TX 2.4G ExpresLRS Micro TX Module For Radio Transmitter TX16S TX12 RC Airplane FPV Drone
Happymodel ES24TX 2.4G ExpresLRS Micro TX Module For Radio Transmitter TX16S TX12 RC Airplane FPV Drone
Happymodel ES24TX 2.4G ExpresLRS Micro TX Module For Radio Transmitter TX16S TX12 RC Airplane FPV Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 20 August, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here