FPV 5.8G 1000mW A/V Transmitter Module (TX)


$88.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
FPV 5.8G 1000mW A/V Transmitter Module (TX) Features: FPV 5.8G 1000mW A/V Transmitting module, a good choice for long range video transmission. Product Details: FPV 5.8G 1000mW A/V Transmitter Module (TX) -video format supported: NTSC/PAL -Antenna connector: SMA jack (module side) -Power input: 7-15V (3S Lipo suggested, does NOT support 4S Lipo) -Transmitting current: 500mA (600mA at 12V under our real testing) -Dimension: 59x27x33 (excluding antenna) *Note: TX antenna must be installed properly before it is switched on, power on without install antenna, or a improper antenna was used may easily burn the TX, and such damage is not covered by warranty. FPV 5.8G 1000mW A/V Transmitter Module (TX) Pulpit rock FPV 5.8G 1000mW A/V Transmitter Module (TX) FPV 5.8G 1000mW A/V Transmitter Module (TX)
  • 10 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 15 April, 2013.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here