High quality FPV aerial figure 5.8 G preach clover antenna


$21.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
-Vertical antenna in the reception of the FPV is getting stronger and stronger. Circular polarization antenna, the antenna is a very good video image stabilization, the characteristics of long transmission distance.
-lover is a closed loop antenna, the signal and the ground wire connection. Clover has three lobes, 120 ° apart from each other in the horizontal plane and the tilted 45 ° in the vertical plane. It may not seem like very nice, but it is definitely a good transmitting antenna. In fact, it is really a best FPV video transmitter antenna
-Clover antenna is the most suitable for launch, it has a good radiation pattern and the very low gain, makes it very effective. It cannot be used in the receiver. Reverse polarization mode rejection is very unstable, change between 8 and 19 class: : dbi. Product Details
Clover is a closed loop antenna, the signal and the ground wire connection. Clover has three lobes, 120 ° apart from each other in the horizontal plane and the tilted 45 ° in the vertical plane. It may not seem like very nice, but it absolutely direction: all-round
Difficulty: high
The most suitable for: video transmitter
Disadvantages: hard, fragile, big, don't move, can't cut to the correct frequency.
Advantages: can achieve good image transmission, good radiation pattern, broadband, low damage, distance is much greater than the original antenna
  • 29 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 09 April, 2013.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here