Large Torque Remote Control Servo Release Hook W/ 433Mhz Remote


$51.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
This remote control release hook come with a 433Mhz remote controller, so it can work without using the drone transmitter. Product Details
Large Torque Remote Control Servo Release Hook W/ 433Mhz Remote controller
Weight: 94g (including servo weight)
High torque MG995 servo, capable of pulling 10 kg load.
Power supply: 2-6S
Power supply connector: JST
Control method: The servo is controlled by a 433Mhz
remote controller come with the release hook.
Operation method:
Press the button "?" (the upper button) to release the hook
Press the button "?" (the lower button) to close the hook or
Press and hold “?” (longer than 3 seconds) to release the hook,
and release the button "?” to close the hook.
Hook Range settings:
Press and hold the “?” button for 5 seconds then release,
the buzzer emits B.B and enters the closing range setting mode
Press ?/? to adjust the range
Press and hold the “?” button for 5 seconds then release,
the buzzer emits B.B.B to enter the opening range setting mode
Press ?/? to adjust the range
Press and hold the “?” button for 5 seconds then release,
the buzzer emits B.B.B.B to Exit setting mode
The range setting will be saved even when power is off.
QA-DJITFQ
Large Torque Remote Control Servo Release Hook W/ 433Mhz Remote controller
Large Torque Remote Control Servo Release Hook W/ 433Mhz Remote controller
Large Torque Remote Control Servo Release Hook W/ 433Mhz Remote controller
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 24 November, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here