SpeedyBee TX800 Maximum 800mW Output 5.8G 48CH FPV VTX Video TX


$35.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
TX800 supports the IRC TRAMP protocol and the modification of video transmission
parameters through the remote control,Including frequency, working power and so on.
If your flight controller supports Bluetooth or WiFi,You can also modify the video
transmission parameters through the SpeedyBee App.
For BetaFlight
flight controller firmware above BetaFlight 4.1.0,
you need upload a VTX Table to the flight controller before using
the remote control to modify the video transmitter parameters
Product Details
Frequency Channel: 5.8G 48CH
Output Power: PIT/25mW/200mW/400mW/800mW
Working Current: 5V@250~750mA
Voltage out: 5V@max 250mA
Voltage in: 3.7-5.5V
Video input impedance: 75 Ohm
Antenna Connector: MMCX
Weight: 5.6g (without antenna)
PCB Size: 28mm*28mm@20*20 M2
SP-TX800
SpeedyBee TX800 Maximum 800mW Output 5.8G 48CH FPV VTX Video Transmitter For FPV Racing Drone
SpeedyBee TX800 Maximum 800mW Output 5.8G 48CH FPV VTX Video Transmitter For FPV Racing Drone
SpeedyBee TX800 Maximum 800mW Output 5.8G 48CH FPV VTX Video Transmitter For FPV Racing Drone
SpeedyBee TX800 Maximum 800mW Output 5.8G 48CH FPV VTX Video Transmitter For FPV Racing Drone
SpeedyBee TX800 Maximum 800mW Output 5.8G 48CH FPV VTX Video Transmitter For FPV Racing Drone
SpeedyBee TX800 Maximum 800mW Output 5.8G 48CH FPV VTX Video Transmitter For FPV Racing Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 20 August, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here