iFlight TurboBee 136RS V2 4S DIY Build Kit with XING-E 1404


$149.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
iFlight TurboBee 136RS V2 4S DIY Build Kit with XING-E 1404 4200KV motor/SucceX Micro F4 V1.5 15A stack for FPV drone
Features
-SucceX Micro F4 Flight tower system
-The lightest 1104 brushless motor on the market with double ball bearings
-Light, Powerful and smooth configuration
-2.5mm bottom carbon fiber frame
-Compatible 4S Lipo/LIHV
Product Details
- Frame Wheelbase: 128mm
- Build Weight: around 65.2g (without battery)
- SucceX Micro 16x16 Tower 2-4S
- XING-E 1104 4200KV motors 60mm wire with plugs
- Caddx.us Turbo Eos V2 2.1mm 16:9 NTSC
- HQProp T3*2 propellers
SucceX Micro F4 V2.1 Flight Controller
-STM32F411
-Input voltage 2-4S LIPO
-Gyro: MPU6000
-2x UART ports
-4x motor outputs
-Betaflight OSD :AT7456E
-Blackbox FLASH: 8MB
-BEC 5V 2.5A cont.
-Size: 21mm*21mm
-Mounting holes distance: 16*16mm
-Weight: 2.5g
-Firmware: IFLIGHT_F411_PRO
NOTE: F.PORT protocol RX input support, telemetry not supported. Recommended battery: (not included)4S 450mAh
Item Packing TurboBee 136RS V2 4S Micro FPV Race Drone (non-assembled) x 1set Detailed Images iFlight Box-TurboBee 136RS V2 4S DIY Build Kit with XING-E 1404 4200KV motor/SucceX Micro F4 V1.5 15A stack for FPV drone
iFlight Box-TurboBee 136RS V2 4S DIY Build Kit with XING-E 1404 4200KV motor/SucceX Micro F4 V1.5 15A stack for FPV drone
iFlight Box-TurboBee 136RS V2 4S DIY Build Kit with XING-E 1404 4200KV motor/SucceX Micro F4 V1.5 15A stack for FPV drone
iFlight Box-TurboBee 136RS V2 4S DIY Build Kit with XING-E 1404 4200KV motor/SucceX Micro F4 V1.5 15A stack for FPV drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 01 March, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here