BUMBLE BEE Four-rotor Quadcopter Folding design ARF


$560.97

 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab

BUMBLE BEE Four-rotor Aircraft Quadcopter Folding design ARF Free Shipping by DHL/FedEx/EMS

   
   
   
   

 

 

Product Details

wheelbase:550mm
height:306mm
Lang Of After Fold:784mm
Height Of After Fold:100mm
Weight:900g
All Weight:1200g
Payload Capability:200~500g
Maximum Gross Take-Off Weight:1700g
Cell Chemistry:11.1V 3S 2200uma/h~5500uma/h Li_poly
Instant Discharge Capacity>20C
Flight Time:>10 minutes
Propeller:ST1038*2pcs,ST1038P*2pcs
ST3512 Brushless Motor:4pcs
ST3512 brushless motor Parameters:
Weight:80g, KV:920rpm/V, No_load Current:0.7A/11.1V, Max current:19A/11.1V
Brushless ESC:20A * 4pcs, Outer diameter :35mm, Stator:diameter:28, height:12mm

bumblebee flight controller:

Manual Mode
Atti. Mode
Height Lock Optional
Auto Level and Descend Fail-Safe
X;Quad-Rotor I, X
Combination Stick Command to Start; Immediately and Intelligent Cut off Type
Remote Tuning
Voltage Monitor and Low Voltage Protection
Self-Check Indication
Center Point Indication
4-Channel Transmitter Support (Default Atti. Mode if U port is not wired)

In the Box

-Four-rotor frame Bumble Bee X 1
-Propellers X 4
-HL3512 brushless motors X 4
-ST20A high speed ESCs X4
-Bumblebee Flight Controller X 1

-Bumblebee instruction manual X 1

Features

- Folding design, easy to carry and store.
- Aluminum frame.
 

  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 20 February, 2012.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here