Carbon Fiber Umbrella Folding FPV Quadcopter Frame 550mm


$99.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
The diagonal wheelbase of the motor base is about 550mm, and the
flat-angle wheelbase is about 395mm, and the maximum support is 15 inches of propellers.
The center board specification 150*150mm has more space, and the middle
height of the center board is about 37mm, making it easier to install the flight controller.
Hanging expansion board, height 45mm, width 45mm. You can put more things, including hanging pan/tilt.
The tripod adopts a carbon tube with a diameter of 16mm, a height of 260mm, and a tripod
crossbar of 330mm, which has more grounding area and more stable.
ZD550 arm carbon tube: 18*20*200mm tripod horizontal tube: 8*10*330mm
tripod vertical tube: 14*16*245mm
Product Details
- Landing gear height: 260mm
- Weight: 630 ±2 g
- Material of the main board : 3k full carbon fiber
- thickness of the main board : 1.5mm
Recommended configuration: (Not included)
- Motor: 3508
- Prop: 12-14 inch CW CCW
- ESC: 30A(2-6s) ; 40A (2-4S)
- Flight control: APM opensource flight control
- Battery: 4-6S Lipo
HSK-ZD550
HSKRC ZD550 550mm Carbon Fiber Umbrella Folding FPV Quadcopter Frame Kit with Carbon Fiber Landing Gear Skid
HSKRC ZD550 550mm Carbon Fiber Umbrella Folding FPV Quadcopter Frame Kit with Carbon Fiber Landing Gear Skid
HSKRC ZD550 550mm Carbon Fiber Umbrella Folding FPV Quadcopter Frame Kit with Carbon Fiber Landing Gear Skid
HSKRC ZD550 550mm Carbon Fiber Umbrella Folding FPV Quadcopter Frame Kit with Carbon Fiber Landing Gear Skid
HSKRC ZD550 550mm Carbon Fiber Umbrella Folding FPV Quadcopter Frame Kit with Carbon Fiber Landing Gear Skid
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 29 October, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here