S500 SK500 PCB Version Multi-Rotor Air Frame Kit


$49.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
- F450 upgrade quad copter
- PCB Center plate with solder point
- Frame only, no electronic parts.
Product Details
model:S500
Wheelbase: 485mm(Maximum support 12 inches propeller)
Weight: 460g
Improvement of tripod:use 16mm pipe diameter 3K pure carbon fiber, weighing about 92g
S500
S500 SK500 PCB Version Multi-Rotor Air Frame Kit W/ Carbon Fibre Landing Gear for FPV Quadcopter
S500 SK500 PCB Version Multi-Rotor Air Frame Kit W/ Carbon Fibre Landing Gear for FPV Quadcopter
S500 SK500 PCB Version Multi-Rotor Air Frame Kit W/ Carbon Fibre Landing Gear for FPV Quadcopter
S500 SK500 PCB Version Multi-Rotor Air Frame Kit W/ Carbon Fibre Landing Gear for FPV Quadcopter
S500 SK500 PCB Version Multi-Rotor Air Frame Kit W/ Carbon Fibre Landing Gear for FPV Quadcopter
S500 SK500 PCB Version Multi-Rotor Air Frame Kit W/ Carbon Fibre Landing Gear for FPV Quadcopter
S500 SK500 PCB Version Multi-Rotor Air Frame Kit W/ Carbon Fibre Landing Gear for FPV Quadcopter
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 26 July, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here