EFT 12S Brush Water Pump Buck Speed Control Flow Regulator


$30.70

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Agriculture Drone special brush water pump step-down governor, $30.70
integrated buck module and governor as one, streamlined wiring,
support 15-60V wide pressure input, external 12V brush pump, built-in
drug detection function, module ring Oxygen resin potting, dustproof and waterproof.
Product Details
Size: 47mm * 34mm * 22mm (without fixed ears)
Weight: 72g
Mounting hole distance: 54-60mm
Supply voltage: 15-60V
Output voltage: 12V
Maximum current: 6A
Maximum power: 72W
Broken medicine line number: there is water - high level, no water - low level
The use of the drug detection function: the drug detection function is currently
limited to the use of 25W water pump, the 3pin line of the drug-breaking signal
is connected to the detection interface of the flight control level meter,
the drug-breaking signal is output in high and low level mode, and water is high.
Flat, no water is low, need to discharge the air in the pump before takeoff,
so as not to misjudge after takeoff.
Item Packing
EFT 12S Brush Water Pump Buck Regulator x 1
EFT-12S-B
EFT 12S Brush Water Pump Buck Speed Control Flow Regulator High Pressure Version for Agriculture Drone UAV Spray System
EFT 12S Brush Water Pump Buck Speed Control Flow Regulator High Pressure Version for Agriculture Drone UAV Spray System
EFT 12S Brush Water Pump Buck Speed Control Flow Regulator High Pressure Version for Agriculture Drone UAV Spray System
EFT 12S Brush Water Pump Buck Speed Control Flow Regulator High Pressure Version for Agriculture Drone UAV Spray System
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 50/116

 Prev 
 All 
 Next 

This product was added to our catalog on Saturday 19 February, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here