Holybro PM06 V2-14S 120A max Power Module for Pixhawk


$27.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Holybro PM06 V2-14S Power Module Applicable for Pixhawk 4 Pixhawk
4 Mini Durandal Pix32 V5 Flight Controller
Product Details
Input voltage: 2S-14S
Power Module rated current: 60A
Power Module max current: 120A (<60 sec)
UBEC output: DC 5.1V~5.3V
UBEC output current: 3A Max (Note: To ensure proper heat dissipation,
UBEC output current needs to be limited to <2A when using 14S battery.)
Voltage Divider: 18.182
Amperes per Volt: 36.364
Mechanical Specification:
Dimensions: 35x35x5mm
Mounting hole: 30.5mm*30.5mm
Weight: 24g
HL-PM06-14S
Holybro PM06 V2-14S Power Module Applicable for Pixhawk 4 Pixhawk 4 Mini Durandal Pix32 V5 Flight Controller
Holybro PM06 V2-14S Power Module Applicable for Pixhawk 4 Pixhawk 4 Mini Durandal Pix32 V5 Flight Controller
Holybro PM06 V2-14S Power Module Applicable for Pixhawk 4 Pixhawk 4 Mini Durandal Pix32 V5 Flight Controller
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 28 June, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here