35kg.cm Digital 180 Degree Metal Steel Gear Iron Core Servo


$32.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
FEETECH 7.4V 35kg.cm Digital 180 Degree Metal Shell Steel Gear Iron Core Servo
Product Details
Model:FT5835M
Storage Temperature Range:-30℃~80℃
Operating Temperature Range:-20℃~60℃
Size:A:40mm B:20mm C: 43mm
Weight:74± 1g
Gear type:Steel
Limit angle:NO limit
Bearing:Ball bearings
Horn gear spline:25T/5.9mm
Case:PA+Aluminum
Connector wire:30CM
Motor:Core Motor
Operating Voltage Range:6-7.4V
Idle current (atstopped):6MA@7.4V
No load speed:0.192sec/60°@7.4V
Runnig current(at no load):290mA@7.4V
Peak stall torque:35.5kg.cm@7.4V
Rated torque:11.8kg.cm@7.4V
Stall current:3.9A@7.4V
Command si gnal:Pulse width modification
Amplifier type:Digital comparator
Pulse width range:500~2500 μ sec
Stop position:1500 μ sec
Running degree:180°(at 500→2500μsec)
Dead band width:≤4 μ sec
Rotating direction: Counterclockwi se (1500→2000 μ sec)
Item Packing
FEETECH 35kg.cm 180 Degree Iron Core Servo x 1

FEETECH 7.4V 35kg.cm Digital 180 Degree Metal Shell Steel Gear Iron Core Servo
FEETECH 7.4V 35kg.cm Digital 180 Degree Metal Shell Steel Gear Iron Core Servo
FEETECH 7.4V 35kg.cm Digital 180 Degree Metal Shell Steel Gear Iron Core Servo
FEETECH 7.4V 35kg.cm Digital 180 Degree Metal Shell Steel Gear Iron Core Servo
FEETECH 7.4V 35kg.cm Digital 180 Degree Metal Shell Steel Gear Iron Core Servo
FEETECH 7.4V 35kg.cm Digital 180 Degree Metal Shell Steel Gear Iron Core Servo
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Sunday 28 March, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here