FEETECH DIY Arduino Smart Robot 15kg programmable RC Servo SCS15


$24.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
FT SCServo is meaning that Smart Control Servo was R&D and manufactured by FEETECH
SCServo can work at servo mode and wheel mode
The servo mode can be used to multi-joints robot since the robots can be controlled with specific angles. (The factory default setting is servo mode)
The wheel mode can be used to wheel-type operation robots since motors of the robots spin infinitely. (If wheel mode is available you need to program the value of position limitation the both are 0.)
If you want to reprogram servo, you need to download the PC software and to connect SCPC-2(or use SCServo controller SCM-1) between servo and PC. Also can use Arduino and TTLinker mini to reprogram it.
SCServo has a unique ID number to identify on BUS network
The range from 0 to 253 (0xFD) can be used (The factory default setting is ID 1), and, especially, 254(0xFE) is used as the Broadcast ID. If the Broadcast ID is used to transmit Instruction Packet, we can command to all SCServo.
After programmed servo ID, to be best way is written it on the sticker of servo. If not, maybe you will forget the ID when you programmed many servos.
SCServo have kinds of baud rate available
The baud rate from 38400 bps to 1M bps can be used.
They are 38400, 57600,76800,115200,128000,250000,500000,1000000. (The factory default setting is 1000000 bps)
Can feedback the value of position, temperature, load, speed and input voltage
How to feedback the value of SCServo please refer Arduino library SCServo.
SCServo is easy to be control by Arduino
SCServo needs to have a TTLinker mini connect to between Arduino and SCServo. If not please reference Schematic of the TTLinker mini.
TTLinker mini is a signal conversion board. Arduino needs to convert its UART signals to the half duplex type and through TTLinker mini connect to SCServo.
TTLinker_mini Connection between Arduino and SCServo
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 27 September, 2018.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here