FEETECH DIY Arduino Smart Robot Human Robot Aluminum Frame


$84.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
DIY 17DOF RoboSoul H3.0 Biped Robotics Two-Legged Human Robot Aluminum Frame Kit Only No Servos controller or Arduino
We recommend FT SCServo is meaning that Smart Control Servo was R&D and manufactured by FEETECH
17DOF Robo-Soul H3.0 Biped Robtic Two-Legged Human Robot Aluminum Frame Kit Only No Servos
Description:
- This robot includes one head, one main body, two arms, two legs, use digital servo power. This robot could finish walking, squat, turning, side slide movements, and could dancing, fighting, or more complicated movements. If with related sensors, could climbing stairs, tracking lines, etc - Color: white/Blue/Red
Specifications:
- Height: 365mm
- Weight: 1650g
- Joints: 17 joints
- Structure: 1mm aluminum alloy strucutre, light weight and high strength
- Recommended servo: LD-2015 digital servo (Not included)
- Controller(not included): 32CH two legs robot controller, with overloading, low voltage alarm
Package Included:
- Robot metal frame set x 1
Recommended configuration:ï¼Not included ¼
- LD-2015 Large Torque Servo x 17pcs
- 15cm servo extension cable x 2pcs
- Voltage step down module x 1
- Charger x 1
- Fastener cable x 20
Note: this package does not include servos or 32CH controller, frame kits only
Two-Legged Human Robot Aluminum Frame Kit
Two-Legged Human Robot Aluminum Frame Kit
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
FEETECH DIY Smart Robot Arduino comp 15kg Servo Feetech SCS15
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 27 September, 2018.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here