RMD-L-12025 24-30V 250W 5N.M brushless dc servo Waterproof motor


$268.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Waterproof RMD-L-12025 24-30V 250W 5N.M brushless dc servo motor
Product Details
Model Number: RMD-L-12025
Motor type: brushless dc servo motor
rated torque: 5N.M
motor driver type: sensored foc control
input voltage: 24-30V
speed: 300rpm/customize
encoder type: 14bit absolute magnet encoder
mechatronics: yes/encoder and driver built in motor
protection: IP56
1.Mechatronics design with built in motor drive and position sensor.
2.Large diameter with more pole pairs design ,providing higher torque and smaller space application.
3.Abundant product models,diameter range:20mm-140mm;torque range:0.02-5N.M
4.Support RMD Assistant setting,simple and easy usin
5.Wide voltage input range,support customize winding
6.Environmental condition of working from -40 to 80 celsius
7.Support multiple communication methods RS485 or Can Bus.
8.Standard industry closed loop control mode(torque /speed/position) and support customize fucntion
9.Support motor speed upto 4000RPM
10.Multiple protection functions,like over temperature,over voltage and over current.
11.Apply for the filed which need precise control low speed and large torque,such as
service robot, laser radar, gimbal and Laboratory test equipment

Waterproof RMD-L-12025 24-30V 250W 5N.M brushless dc servo motor
Waterproof RMD-L-12025 24-30V 250W 5N.M brushless dc servo motor
Waterproof RMD-L-12025 24-30V 250W 5N.M brushless dc servo motor
Waterproof RMD-L-12025 24-30V 250W 5N.M brushless dc servo motor
Waterproof RMD-L-12025 24-30V 250W 5N.M brushless dc servo motor
Waterproof RMD-L-12025 24-30V 250W 5N.M brushless dc servo motor
Waterproof RMD-L-12025 24-30V 250W 5N.M brushless dc servo motor
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 28 April, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here