RMD-X10 7:1 GEAR RATIO CAN OR RS485 robot actuator


$669.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
RMD-X10 7:1 GEAR RATIO CAN OR RS485 COMMUNICATION High-Torque robot actuator $669.00
A00082
Reducer ratio 7 : 1
input voltage V 24-48
No -load Speed rpm 250 @48V
Nominal Speed rpm 210
Nominal current A 11
Nominal power W 420
Nominal torque N.M 19
motor efficiency % 78%
resistance ? 0.3
wire connect Y
Phase to phase inductance mH 0.13
Speed constant rpm/v 36
Torque constant N.M/A 1.73
Axial direction payload N.M 1625
Radial direction payload N.M 2250
Rotor inertia gc? 5675
Number of pole pairs 21
Motor weight g 1190
Environment temperature ? (-20 ~ 55 ?)
Backlash Arc min 5
Product Details
X10 MOTOR robot actuator servo motor gear motor 7:1 ratio
RMD-X10 7:1 GEAR RATIO CAN OR RS485 COMMUNICATION High-Torque robot actuator
RMD-X10 7:1 GEAR RATIO CAN OR RS485 COMMUNICATION High-Torque robot actuator
RMD-X10 7:1 GEAR RATIO CAN OR RS485 COMMUNICATION High-Torque robot actuator
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Tuesday 28 September, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here