SDC200 Universal Driver Board Speed ​​Control for Gimbal Camera



$115.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
This driver is suitable for all brushless DC motors with encoder.
Support both RS485 and CAN bus communication.
Wide voltage input range, working voltage 12V~36V (maximum support 48V)
All signal terminals adopt GH1.25 terminal to ensure the
reliability of signal connection
Driver board integrates a USB interface, which is convenient to
connect to upper computer for parameter debugging
Support RS485 and CAN bus interface
The baud rate of RS485 and CAN interface both can be configured by upper computer
L 'driver board device address can be set up by upper computer
Provide upper computer parameter setting software for free
Driver board working temperature is -40~85℃ ℃
Multiple protection functions, over voltage / over current
Used in medium and low speed, high torque precision servo control occasions,
such as high-tech robots / lidar / education and scientific research unit
experimental device test equipment / safety inspection/surveying
and exploration equipment
Product Details
The correspondence of the line connection between the driver board and the encoder board:
5.0V-VDD5V, GND-GND, MOSI-MOSI, MISO-MISO, SCK-CLK, cs-csn
SDC200
SDC200 Universal Driver Board Speed ​​Control for Gimbal Camera Motor, FOC BLDC Motor Controller with High Precision Position
SDC200 Universal Driver Board Speed ​​Control for Gimbal Camera Motor, FOC BLDC Motor Controller with High Precision Position
SDC200 Universal Driver Board Speed ​​Control for Gimbal Camera Motor, FOC BLDC Motor Controller with High Precision Position
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 64/82

 Prev 
 All 
 Next 

This product was added to our catalog on Saturday 07 May, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here