X8 RDM encoder Brushless geared SERVO Motor 32bit control unit


$450.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
X8 - RDM encoder Brushless geared SERVO Motor 32bit control power unit
This is NEW Driver board for BGC motor RMD-S and RMD-L, ONLY Difference is installed a different driver board with RS-485 industrial communication used for robot and other Automation. This motor is best for servo gimbals, turntables, robots. The motor have the same size and fixed holes, RMD-S and RMD-L servo motors are compatible with or BGC driver board.
RMD-S and RMD-L are based on RS-485 industrial communication ,the advantage is anti-jamming ability. (suitable for long distance transmission´╝ëand also the motor speed higher used for robot and other Automation field etc Express shipping only by DHL FedEx $60USD INT
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
geared  sensored brushless joint servo motor with 32bit controller RS332
  • 1000 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 16 September, 2019.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here