14-Ch PWM to S.BUS Signal Converter / Encoder


$37.89

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Suit for converting signal from conventional PWM signal receivers to Futaba S.bus signal, you can use none-S.Bus signal receivers with fly control like DJI etc which using S.Bus connection.
Support up to 14 channels signals, you can encode 12 proportional channels and two switch channels signals into S.Bus signal.
* Note: This module is NOT a receiver, but a signal coding module for conventional PWM receivers.
Product Details
14-Ch PWM to S.BUS Signal Converter / Encoder
-Supported coding: PWM signals, 12 proportional channels and two switch channels signals
-Power supply: 5V
-Max channel number: 14Ch




  • 96 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 16 July, 2015.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here