FLYSKY FGR8B 2.4GHz 8CH Receiver PWM PPM Ibus for AFHDS3 Tx


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
The FGr8B receiver adopts Flysky's third-generation automatic frequency
hopping digital system (AFHDS 3).It uses a single-antenna bidirectional
transmission system and is uniquely designed to install and output
PWM/PPM/ i-bus in signals. It supports all AFHDS3 transmitter and RF modules.
Product Details
Product Model: FGr8B
Adaptive transmitter: all transmitter supporting AFHDS3 (PL18, NB4,
NB4 Lite, etc.)
Model Type: Car/Boat ect.
PWM Channels: 7(Version 2.0 will be upgraded to 8 channels))
RF: 2.4GHz
2.4G Protocol: AFHDS 3
Antenna: Single Antenna
Input Power: 3.5-9V
Data Output: PWMPPMi-bus in
Temperature Range: -10℃—+60℃
Humidity Limit: 20%-95%
Online Update: Yes
Dimensions: 35*23.3*13.3mm
Weight: 9.4g
Certification: CE,FCC ID:N4ZFGR8B
FLYSKY FGR8B 2.4GHz 8CH Receiver PWM PPM Ibus for AFHDS3 Transmitters PL18/ NB4 /NB4 Lite
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Wednesday 27 October, 2021.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here