FrSky RX8R PRO Receiver FCC Redundancy 2.4GACCST 8/16 SBUS Telem



$65.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
An upgraded version based on the RX8R receiver, it has all the same features
including redundancy. The Pro version has higher precision and lower latency.
It’s deviation of PWM is reduced to 0.5us, and the delay of PWM output is 9ms
less than that of the X8R in high speed mode. A feature that deserves mention
is the decreased effect of interference caused by the ignition process.
* Strong anti-interference performance in ignition process
* Higher precision of PWM
* Lower latency on the PWM output
* Support redundancy function
* Smart Port enabled and support telemetry data transmission
Product Details
Dimension: 46.3mm*26.6mm*14.2mm (L*W*H)
Weight: 14.8g
Numbers of Channels: 16CH(1~8CH PWM or 9~16CH PWM from conventional
channel outputs, 1~16CH from SBUS port)
With RSSI Output on Board: Analog DC 0~3.3V
Operating Voltage Range: 3.5V~10V
Operating Current: 100mA@5V
Operating Range: full range (>1.5km)
Firmware Upgradeable
Servo Frame Rate: 9ms (HS—High Speed Mode)/18ms (FS—Normal Speed Mode)
Compatibility: FrSky transmitters/transmitter modules in D8/D16 mode
RX8R-PRO
FrSky RX8R PRO Receiver FCC Including Redundancy 2.4G ACCST 8/16CH SBUS Telemetry Receiver For FrSky Transmitters/Transmitter Modules in D8/D16 Mode
FrSky RX8R PRO Receiver FCC Including Redundancy 2.4G ACCST 8/16CH SBUS Telemetry Receiver For FrSky Transmitters/Transmitter Modules in D8/D16 Mode
FrSky RX8R PRO Receiver FCC Including Redundancy 2.4G ACCST 8/16CH SBUS Telemetry Receiver For FrSky Transmitters/Transmitter Modules in D8/D16 Mode
FrSky RX8R PRO Receiver FCC Including Redundancy 2.4G ACCST 8/16CH SBUS Telemetry Receiver For FrSky Transmitters/Transmitter Modules in D8/D16 Mode
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Monday 25 July, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here