Happy model ExpressLRS ELRS EPW6 900MHz 6CH PWM RC Receiver


$15.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Default firmware version: Express LRS v2.0
Firmware target:
DIY_900_RX_PWMP(Factory default firmware), PWM receiver via 1~6 PWM outputs
HappyModel_RX_ES900_RX, CRSF Serial receiver via TX and RX
Firmware update via UART or WIFI
Bind Procedure:
1.Supply power to the EPW6 RX, wait until the Green LED on the RX
is off, immediately turn off the power, and then repeat again the above steps.
When the RX is powered on for the third time, the Green LED light will
start to double-flash, which means that the RX enters the binding mode
2.Get into menu of ELRS.LUA V2.0 version from your radio transmitter and
then press BIND, the Green LED on the RX module will getting
to be solid if bind
Receiver LED status meanings:
LED solid means bind successful or Connection established;
LED double-flash means in bind mode; LED flash slowly means no signal
connection from the TX module; LED flash fast means in WIFI hotspot mode,
you can connect the WIFI of the RX and upgrade firmware of the RX via
visit 10.0.0.1 from the web browser(password: express lrs)
Product Details

Item: Happy model EPW6 900MHz pwm receiver
ESP8285, SX1276
Antenna connector: IPEX MHF 1/U.FL
6x PWM outputs
RF Frequency: 868MHz(EU), 915MHz(FCC)
Telemetry power: <17dbm
Receiver protocol: PWM or CRSF
Input voltage: +5V DC @ "+" pad
PCB size: 18.5mm x 16mm
Weight: 1 g without antenna
EPW6-900MHZ
Happy model ExpressLRS ELRS EPW6 900MHz 6CH PWM RC Receiver For Fixed-wing Airplane
Happymodel ExpressLRS ELRS EPW6 900MHz 6CH PWM RC Receiver For Fixed-wing Airplane
Happymodel ExpressLRS ELRS EPW6 900MHz 6CH PWM RC Receiver For Fixed-wing Airplane
Happymodel ExpressLRS ELRS EPW6 900MHz 6CH PWM RC Receiver For Fixed-wing Airplane
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Sunday 23 January, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here