Hobby Eagle A3 EVO Flight Controller Stabilizer 3-Axle Gyro


$40.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
A3 EVO is the latest fixed-wing dedicated 6-axis gyroscope developed on
the AVR platform. The algorithm is simple, efficient, mature and stable.
It continues and draws on the rich experience of previous gyroscope
development and adds many new features, such as PPM receiver support,
independent 3-axis basic sensitivity adjustment, and independent throttle
output channel for mini receivers, A3EVO will bring you more
powerful and outstanding performance.
- 4 flight modes: gyroscope off mode, normal stabilization mode,
automatic balance mode, automatic hoist mode
- 3 types of airfoil: conventional airfoil, delta wing (flying wing) and v-tail
- Support standard PM receiver PPM and Q Futaba. bus serial receiver
- Throttle signal output in serial mode
- Independent adjustment of basic sensitivity of aileron, lift and direction
- Remote total sensitivity adjustment
Product Details
Main controller: AVR microprocessor
Sensor: High-precision MEMS six-axis sensor
Gyro range: ±2000dps
Acceleration measurement range: ±4g
Servo stroke: limited to 970uS-2070uS, 1520uS for the central defender
Working voltage: 4.8V-8.4V (up to 2S lithium battery direct power supply)
Working temperature: -10℃-50℃
Size: 43*27*14mm
Weight: 10g
HE-A3EVO
Hobby Eagle A3 EVO Flight Controller Stabilizer 3-Axle Gyro For RC Airplane Fixed-wing Copter Drone
HobbyEagle A3 EVO Flight Controller Stabilizer 3-Axle Gyro For RC Airplane Fixed-wing Copter Drone
HobbyEagle A3 EVO Flight Controller Stabilizer 3-Axle Gyro For RC Airplane Fixed-wing Copter Drone
HobbyEagle A3 EVO Flight Controller Stabilizer 3-Axle Gyro For RC Airplane Fixed-wing Copter Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 113/178

 Prev 
 All 
 Next 

This product was added to our catalog on Sunday 23 January, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here