Hotrc HT-6A 2.4G 6CH RC FHSS Transmitter and 6CH Receiver


$38.99

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
The 2.4GHz radio band is completely different from the low-frequency radio
band used before. Please ensure that the model product is
flying within your eyesight when using it.
During the use, it is strictly forbidden to grip the transmitter antenna,
otherwise it will reduced the quality and strength of the wireless antenna
propagation signal and may cause the remote control and the model out of control.
Product Details
Model Type: Model airplane/Drone/Car/Boat
Channels:6
RF Range:2.4GHZ ISM(2.4005-2.483.5GHZ)
RF Power:<100mW
Modulation: GFSK
Spread spectrum: FHSS
Reaction speed: PWM<20ms SBUS<6.8ms
RF Distance:Ground:400M Aerial:800M
Receive Sensitivity:<-97dbm
Transmitter voltage: DC 4.5V-9V
Receiver voltage: DC 4.5V-6V
Weight:310g
Certificate:CE0678 FCC
HT-6A
Hotrc HT-6A 2.4G 6CH RC FHSS Transmitter and 6CH Receiver With Box Used For FPV Drone RC Airplane RC Car RC Boat
Hotrc HT-6A 2.4G 6CH RC FHSS Transmitter and 6CH Receiver With Box Used For FPV Drone RC Airplane RC Car RC Boat
Hotrc HT-6A 2.4G 6CH RC FHSS Transmitter and 6CH Receiver With Box Used For FPV Drone RC Airplane RC Car RC Boat
Hotrc HT-6A 2.4G 6CH RC FHSS Transmitter and 6CH Receiver With Box Used For FPV Drone RC Airplane RC Car RC Boat
Hotrc HT-6A 2.4G 6CH RC FHSS Transmitter and 6CH Receiver With Box Used For FPV Drone RC Airplane RC Car RC Boat
Hotrc HT-6A 2.4G 6CH RC FHSS Transmitter and 6CH Receiver With Box Used For FPV Drone RC Airplane RC Car RC Boat
Hotrc HT-6A 2.4G 6CH RC FHSS Transmitter and 6CH Receiver With Box Used For FPV Drone RC Airplane RC Car RC Boat
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Sunday 23 January, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here