Jumper R1 V2 Mini 2.4GHz 16CH Receiver FrSky D16 XM+ RXSR SBUS


$20.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Binding is the process of uniquely associating receiver to a transmitter/transmitter RF module.
A transmitter internal or external RF module can be bound to multiple receivers
(not to be used simultaneously).A receiver can only be bound to one RF module.
Follow the steps below to finish the binding procedure.
- Put the transmitter/transmitter RF module into binding mode
- Connect battery to the receiver while holding the F/S button
(hold for more than 6 seconds) on the receiver to enter the binding mode
(red and green LEDs constant on). Press "bind" on the transmitter, the RED LED
flashing indicates binding successfully. Reboot the receiver and go back to
normal Mode of transmitter RF. Green LED constant on indicates linking normally.
Product Details
Brand Name: Jumper
Item Name: R1 V2 Mini RC Receiver
Model: R1 V2 Mini
Dimension: 17.2*8.8*4.5mm (L x W x H)
Weight: 1.5g
Number of Channels: 16Ch
Operating Voltage Range: 3.5V-6V
Operating Current: 60mA@5V
Operating Range: Full range
Distance: >2KM
Compatibility: radios in D16 mode
1 x R1 V2 Mini RC Receiver
1 x Manual
JP-R1V2
Jumper R1 V2 Mini 2.4GHz 16CH Receiver Compatible with FrSky D16 XM+ RXSR SBUS Jumper T-Lite T18 T16 T12 T8SG Drone Accessories
Jumper R1 V2 Mini 2.4GHz 16CH Receiver Compatible with FrSky D16 XM+ RXSR SBUS Jumper T-Lite T18 T16 T12 T8SG Drone Accessories
Jumper R1 V2 Mini 2.4GHz 16CH Receiver Compatible with FrSky D16 XM+ RXSR SBUS Jumper T-Lite T18 T16 T12 T8SG Drone Accessories
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 116/178

 Prev 
 All 
 Next 

This product was added to our catalog on Friday 15 April, 2022.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here