Jumper T-PRO OpenTX JP4IN1 built-in Multi-Protocol & ELRS Modul


$170.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
JP4-in-1 Multi-protocol module included. DSM2/X, FrSKY, SFHSS,
FlySky, FlySky AFHDS2A, Hubsan etc.
OpenTX firmware
Hall sensor gimbals
ELRS Nano / TBS CRSF Nano compatible module bay on rear side.
USB-C internal chargingv Up to 16 channels of output (depending on the receiver)
Wide voltage input (2pcs 18650 recommended)
Vibration reminder function
Support telemetry (depending on the receiver)
LUA Script support: Yes
Product Details
Jumper T-Pro Transmitter
Size:160*128*68
Weight: 488g (without battery)
Working voltage: DC6V-DC8.4V
Firmware: OpenTX
Display: 1.3 inch LCD display, 128* 64 resolution
Gimbal Type: HALL Sensor
Upgrade method: USB online upgrade
Simulator mode: 3.5mm standard ppm output or USB
Battery: 2x18650 (Battery not included)
External Micro SD Card: reserved SD card slot
Note:the remote controller not include battery,18650 2600mah Batteries
ELRS Module
Model: AION ELRS2.4TX-NANO
Main control chip: ESP32
Transmitting power: 10-500mw
Frequency bandwidth: 2.4GHz-2.5GHz
Compatible firmware: ELRS
Antenna form: omnidirectional high gain diamond antenna
Quick socket: NANO interface
Working voltage: DC5-8.4v
Maximum refresh rate: 500Hz
Screen form: 0.96 inch white light OLED
Screen resolution: 128*64
Menu button: five-way joystick
Upgrade method: UBC-C or Bluetooth
Simulator: supports Bluetooth and WIFI wireless mode
Weight:187g
Module Size:6.4*5.2*4cm
T-PRO-ELRS
Jumper T-PRO OpenTX Transmitter JP4IN1 built-in Multi-Protocol Module Remote Control With ELRS Module
Jumper T-PRO OpenTX Transmitter JP4IN1 built-in Multi-Protocol Module Remote Control With ELRS Module
Jumper T-PRO OpenTX Transmitter JP4IN1 built-in Multi-Protocol Module Remote Control With ELRS Module
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 30 December, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here