SBUS1 to PPM Decoder (Supporting 10CG, 14SG)S



$38.39

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
This product can be used to decode S.BUS1 signal to PPM signal for conventional analog or digital servos with SBUS receivers.
When use Futaba 10CG, you can decode to 10 proportional channels, and when use Futaba 14SG, you can decode the signal to 12 proportional channels and two switch channels.
* Note: This module is NOT a receiver, but a signal decoder for receivers supporting S.Bus1.
Product Details
SBUS1 to PPM Decoder (Supporting 10CG, 14SG)
Supported coding: Futaba S.Bus1
Power supply: 5V
Max channel number: 14Ch




  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Thursday 16 July, 2015.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here