SpeedyBee Bluetooth Uart Adapter Module Support Betaflight


 Sold Out 

  • Description
  • Details
  • Reviews
  • Custom Tab
No Blue-tooth signal interference during the flight
*Throttle Armed, turn off the Blue-tooth-UART Adapter
* Throttle Disarmed, turn on the Blue-tooth-UART Adapter
Betaflight Configurator Supported
iOS and Android APP allow you to connect the Flight controller PCB via a mobile device for parameters settings.
* iOS 10.0+ : iPhone4S, iPad 3rd Gen and later
* Android 4.3+
Product Details
Output Power: 0dBm
Receiver Sensitivity: -94 dBm
External Interfaces: BROADCAST SWITCH, TX, RX, 3~5V DC Input, GND
Transmission rate: Bidirectional 1K/S
Blue-tooth Protocol: Blue-tooth Specification V4.0 BLE
Transmission distance: 30m
Frequency range: 2400 MHZ - 2483.5MHZ(2.4G ISM Band)
Baud rate: 2400,4800,9600,14400,19200(default),28800,38400, 57600,76800,115200,230400
Operating Voltage: 3.3V - 5.0V DC
Working current: 8.3mA~10mA
Weight: 1.4g
Dimensions: 27*15*4.5mm
  • 0 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Tuesday 26 June, 2018.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here