TTSRC X9 Remote Control 2.4G 9CH Transmitter & X9D Receiver



$117.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Stylish, ultra-thin, low power.
The product has added an innovative design of accelerator switch based on the remote
control of the same industry, making it convenient for both right-handed and left-handed users.
With 2.8" color screen, you can get different results by different controls to the LCD controller,
and record the shape of the English or Chinese characters.
Comfortable to control the transmitter stick, it makes the flight very smooth
RF range: on ground 1000M, in air 3500M. Excellent anti-interference capability
Product Details
Item numer: X9
Channels: 9
Working Voltage: 7V-18V
Working Current: 190mAh
Model Type: Fixed-Wing/ Glider/ Helicopter/Car/Boat/Multi-rotor/UAV
Transmission Frequency: 2.4GHz ISM band (2400MHz-2483.5MHz)
Transmission Power: less than 100mW (20dbm)
Modulation Mode: GFSK
Bandwidth: 0.5MHz
Spread Spectrum: AT-FHSS (two-way communication)
Stick Resolution: 4096
Antenna Length: 130mm (Dual Antenna)
Weight: 720g
Display: 2.8inch Color Screen, 320 * 240 resolution
Receiver Sensitivity: -107db
Remote Control Distance: 3.5 km in the air, 1 km at ground (according to the actual situation)
Controller Size: 175 * 175 * 60mm
Receiver Size: 25 * 47 * 14mm
Color: Grey
Support Receiver: all TTSRC receivers (X9D, 18RD, SZ007X7)

TTSRC X9 Remote Control 2.4G 9CH Transmitter & X9D Receiver for RC Airplane Racing Drone
TTSRC X9 Remote Control 2.4G 9CH Transmitter & X9D Receiver for RC Airplane Racing Drone
TTSRC X9 Remote Control 2.4G 9CH Transmitter & X9D Receiver for RC Airplane Racing Drone
TTSRC X9 Remote Control 2.4G 9CH Transmitter & X9D Receiver for RC Airplane Racing Drone
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Wednesday 10 March, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here