VESC 100V400A 22S ESC BLDC controller VESC Firmwares Bluetooth


$699.00

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
Expresses Shipping only for this item int by DHL/FedeX $69-$90usd
The VESC 100V/400A controller is being configured with the brand new Open Source,
GPL V3 licensed VESC®-Tool Software: www.vesc-project.com
The Open source, GPL V3 licensed VESC Firmwares will come pre-installed on the device,
allowing us to do extra testing of the device, prior to shipping.
This is the GPL V3 license contract for your reference showing here on the Vesc-Project website
add any battery delivering up to 100V of max peak voltage (e.g.22S Lithium + voltage spikes).
This is the perfect limit to give you incredible performance from your battery driven electric motors.
Using the new VESC TOOL Original (which you will get access to once you have made your purchase)
or the VESC-App for Android, you will be able to fine tune your performances relevant to your
application, while you will see all the real time data that the VESC computes and outputs.
Speed, RPM, current consumtion, duty cycle, battery capacity and state of charge, Wh consumtion
and WH regen, estimated range, realtime data graph plotting etc. Beautiful! Even firmware
updates and configuration can be done wirless now.
Product Details
The 100/250 features the following ports and outputs:
- Sensor port for motor sensors (ABI, HALL, AS5047p magnetic precission encoders)
- CAN Port for CAN communication with other devices and VESC arrays ( CAN and UAV CAN).
- PPM port to connect PPM tranccievers
- COMM port for various kinds of other communication methods like I2C, ADC, Uart, SPI.
You can use your Arduino or RaspberryPi to control the VESC!
- SWD port to get direct access to the chipset. diagnostics, debugging, and real time data.
- AUX port to supply 12V and 5V to external devices.
- USB
- NRF52840 BLE wireless bridge
The VESC 100/250 controllers come fitted as standard with TRAMPA's very own & very
special Silicone Coated & TRAMPA logo'd cables which are made up of 1036 Strands of
Highly Flexible Top quality Copper. These quality details ensure the maximum performance
at all times. Attached To the premium copper cables are three genuine Amass XT90 connectors
on the battery side allowing you to push up to 300 battery Amps. Using multiple high quality
silicone cables on the motor side ensures your power flows to the max. Thicker cables would
be hard to bend and would consume more space than necessairy, while multiple smaller cables
can be routed with ease to your phase wire connection point while keeping the housing as
small as humanly possible.

VESC 100V/400A 22S ESC controller VESC Firmwares Bluetooth connect 12V & 5V BEC
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

Product 123/125

 Prev 
 All 
 Next 

This product was added to our catalog on Thursday 08 April, 2021.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here