Happymodel Mobula7 75mm 1S Micro FPV Whoop Drone With 5IN1 AIO

(image for) Happymodel Mobula7 75mm 1S Micro FPV Whoop Drone With 5IN1 AIO
Happymodel Mobula7 75mm 1S Micro FPV Whoop Drone With 5IN1 AIO
  • 100 Units in Stock

 Ask a Question 

$190.00

Add to Cart:
Features
X12 5-IN-1 AIO flight controller built-in 2.4G ELRS V2.0 and Openvtx
VTX Power up to 400mw
ELRS V2.0 Support
NEW RS0802 KV20000 motors
Runcam Nano3 The lightest 1/3 CMOS 800TVL Camera
Smooth and powerful
Compatible for 1S Lipo/LIHV
Recommend 1S 450mah/550mah/650mah battery(Not include)
Product Details
Brand Name: Happymodel
Item Name: Mobula7 1S 75mm Micro FPV whoop drone
Wheelbase: 75mm
Size: 99mm*99mm*40mm
Weight: 24g
Motor
-- Mode: RS0802 KV20000
-- Configu-ration:9N12P
-- Stator Diamter:8mm
-- Stator Length:2mm
-- Shaft Diameter:F1.5mm
-- Motor Dimension(Dia.*Len):F10.5mm*13.5mm
-- Weight(g):2.0g
-- No.of Cells(Lipo):1S only
Propellers
-- Weight:0.24g
-- Material:PC
-- Pitch:1 inch
-- Props Dia:40mm
-- Center Thickness:5mm
-- Center Hole Dia:1.5mm
Flight controller
-- X12 ELRS V1.0 flight controller built-in ELRS 2.4G receiver Target: CRAZYBEEF4SX1280
-- MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
-- Sensor: MPU6000 or ICM20689(SPI connection)
-- Mount hole size: 25.5mm*25.5mm
-- Power supply: 1S battery input (DC 2.9V-4.35V)
-- Built-in 12A(each) Blheli_S 4in1 ESC
-- Built-in Betaflight OSD(SPI Control)
-- Built-in 5.8G OpenVTX 0mw~400mw
-- Built-in ExpressLRS 2.4G,Frsky D8/D16,Flysky AFHDS 2A
-- Built-in voltage detection
-- Built-in current sensor
Onboard 4in1 ESC
-- Power supply: 1S LiPo/LiPo HV
-- Current: 12A continuous peak 15A (3 seconds)
-- Support BLHeliSuite programmable
-- Factory firmware: Z_H_30_REV16_7.HEX
-- Default protocol: DSHOT300
-- Support Bluejay firmware
Onboard SPI ExpressLRS 2.4GHz Receiver
-- Packet Rate option: 50Hz/150Hz/250Hz/500Hz
-- ExpressLRS Firmware version: V2.0
-- RF Frequency: 2.4GHz
-- Antenna : SMD antenna
-- Telemetry output Power: <12dBm
-- Receiver protocol: SPI ExpressLRS
-- Compatible with ExpressLRS V2.0 TX Module
-- Couldn’t flash separately ExpressLRS firmware
Onboard 5.8g OPENVTX
-- Firmware version: OPENVTX
-- Smartaudio v2.1
-- PIT Mode support
-- RCE Mode support
-- Channels:48ch
-- Transmitting Power: 0/RCE/25mw/100mw/400mw
-- Power supply: DC 5V
-- Current (5v): <650ma (400mw)
Runcam Nano3
-- Model: RunCam Nano 3
-- Image Sensor: 1/3" CMOS
-- Horizontal Resolution: 800TVL
-- Lens: 2.1mm(M8) FOV 150°
-- Signal System: NTSC
-- S/N Ratio: >50dB
-- Electronic Shutter Speed: Auto
-- Auto Gain Control (AGC): Auto
-- Min. Illumination: 0.01Lux@1.2F
-- D-WDR: Auto
-- Day/Night: Color
-- Power:DC 3-5.5V
-- Current: 110mA@5V 120mA@3.3V
-- Housing Material: ABS
-- Net Weight: 1.2g
-- Dimensions: L14mm*W14mm*H9mm
Lipo Battery(Not include)
-- Capacity:650mAh
-- Voltage:3.8v
-- Continuous Discharge Rate: 30C
-- Instantaneous discharge rate: 60C
-- Size: 60mmx18mmx8mm
-- Weight: 16g
-- Connector: PH2.0
MOBULA7-ELRS
Happymodel Mobula7 75mm 1S Micro FPV Whoop Drone With 5IN1 AIO Flight Controller Built-in 2.4G ELRS V2.0 RX Nano3 1/3 CMOS
Happymodel Mobula7 75mm 1S Micro FPV Whoop Drone With 5IN1 AIO Flight Controller Built-in 2.4G ELRS V2.0 RX Nano3 1/3 CMOS
Happymodel Mobula7 75mm 1S Micro FPV Whoop Drone With 5IN1 AIO Flight Controller Built-in 2.4G ELRS V2.0 RX Nano3 1/3 CMOS
Happymodel Mobula7 75mm 1S Micro FPV Whoop Drone With 5IN1 AIO Flight Controller Built-in 2.4G ELRS V2.0 RX Nano3 1/3 CMOS
Happymodel Mobula7 75mm 1S Micro FPV Whoop Drone With 5IN1 AIO Flight Controller Built-in 2.4G ELRS V2.0 RX Nano3 1/3 CMOS
Happymodel Mobula7 75mm 1S Micro FPV Whoop Drone With 5IN1 AIO Flight Controller Built-in 2.4G ELRS V2.0 RX Nano3 1/3 CMOS

Product 27/60

 Previous 
 Return to the Product List 
 Next 

This product was added to our catalog on Sunday 27 March, 2022.

Copyright © 2024 OFF THE GRID WATER. Powered by Zen Cart