520 Line Super Light 4g CMOS Camera MC900D-V9 PAL


$45.20

Add to Cart:


  • Description
  • Details
  • Reviews
  • Custom Tab
Features
1. Small Size: easy to install into narrow room and slim tube, etc.;
2. Light Weight: easy install without causing unnecessary damage on object surface;
3. High resolution, high sensitivity, high SNR;
4. Day & night dual mode auto switch;
5. Low Illumination, high quality video record function;
6. Low Current and power consumption;
7. CMOS sensor generation IV+DSP chip offer true color & HD video
Product Details
Resolution: 900 line HD camera
Power input: 6-30V wide range input
Transmitter module:
Power: 200mW
Band: 5.8G
Channel number: 32Ch
Video format supported: P / N /S automatic
Antenna connector: SMA, jack (Module side)
Gimble:
Axis number: 2
Servo voltage: 4.8-6V
PICK UP ELEMENT: Single chip 1/3 CMOS
SYSTEM: PAL
NUMBER OF PIXEL: 786(H)×576(V)
SENSOR DIMENSION:
4.75mm(H)×3.55mm(V)
HORIZONTAL RESOLUTION: Approximately 480TV Lines
SENSITIVITY: 0.008Lux/F1.2
LENS & VIEW ANGLE: 0.5mm F1.2 / 90°
S/N RATIO: 48dB
AUTO GAIN CONTROL: OUT
WHITE BALANCE CONTROL: OUT
BACK LIGHT COMPENSATION: OUT
VIDEO OUT: 1.0V p-p/75ohm
AUDIO OUT: 1.0V p-p/1Kohm
WEIGHT : 4g
WORK CURRENT: DC12V: 35mA
POWER REQUIREMENT: DC12V:(4-24V )
OPERATING TEMPERATURE: - 10° C ~ +50°C ,less than 90% RH
Connection: PIN1 -> Red DC5V /12V; PIN2 -> Black GND; PIN3 -> Yellow VIDEO
OUT; PIN4 -> White AUDIO OUT


  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip


This product was added to our catalog on Friday 14 November, 2014.

Content

OFFTHEGRIDWATER.CA

Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.



your alt text here