LD-Power 2212A Gimbal Brushless Motor (for 100-300g Cameras)


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
-Specially designed for brushless gimbal, suit for gimbals for card cameras like Gopro or cameras within 100-300g in weight. Product Details
-LD-Power 2212A Gimbal Brushless Motor
-Weight: 50g / 1.77oz
-Shaft Diameter: 3.17mm
-Motor diameter: 28mm
-Length: 31mm
-Bottom mounting holes: 16 and 19mm center to center
-Top mounting holes: 12mm center to center approx. ( 3 holes at 120 degrees)
-Load weight: 100-300g cameras like Gopro
-Connector type: Futaba/JR compatible
-Wire length: 15cm (including connector)
  • 100 Units in Stock

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Monday 24 June, 2013.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here