FLYCAT 4-axial DIY Frame W/ 2 Gimbals (Camera Mounts) V2 - High


Add to Cart:

  • Description
  • Details
  • Reviews
  • Custom Tab
-This DIY frame can adopt most popular flight control including DJI NAZA fly control.

It come with two camera mounts/Gimbals suit for camera like GoPro and other card type cameras.

Product Details:
FLYCAT 4-axial DIY Frame W/ 2 Gimbals (Camera Mounts) V2 - High Landing Skid

Motor spacing(distance between motor axles, cross side): 480mm
Mode: 4-axial
Electronics and propellers are not included, to be purchased separately.

Suggested setting (not included):

Brushless motor: HL 4225-610.
Battery: 3000-4000mAh 4S
Suggested prop: 10x4.5 3-blade

  • 100 Units in Stock
  • Manufactured by: DJI

Be the first to write a review.  Write a Review.
Safety Tip

This product was added to our catalog on Monday 18 March, 2013.



Rc-toys Multi Rotor safty Tip Keep your PROPS OFF not installed until you are fully conversant/understand in full the functions of your Tx in full including TRAV (end Points), the arm and disarm procedures - realise that for a noob skiping or out-of-order set-up steps or moving sticks, or even static - PROPS may start at anytime without warning. Never install props prior to calibration of the ESC and testing the gyro orientation, and arm/disarm testing of the board - YOU are responsible - make sure your actions and your Copter is safe. Never ASSUME the props will not start - removing the props removes the risk.

your alt text here